|
Below, you'll find extensive information on leading
boat insurance articles and products to help you on your way
to success.
Mooring To A Pontoon Or Dock
By Simon White
Boats are amongst the most expensive purchases one will make in their lifetime, so it is well worth protecting the investment by mooring with the correct technique and using good quality ropes and fenders
Nylon lines are good as they tend to last a long time, wear well and have some elasticity which reduces the effect of shocks on your caused by movement.
If your is to be left moored up for a long time, especially over winter, it's a good idea to double up on the mooring lines. This spreads the load, extending the life of your lines and provides a backup should one fail. It is a good idea to add chafing gear to parts of the lines that will be subjected to wear, for example where they run through fairleads. Chafing gear can be a leather wrapping, an additional layer of braiding or a used fire hose or similar.
Marinas are often busy and sometimes it'll be difficult to find a mooring especially in peak season. Plan to arrive early at your marina before it becomes crowded if you expect space to be at a premium. It is also a good idea to radio ahead to the marina letting them know your vessel size. They will often point you in the right direction to an empty berth - saving you the effort of searching.
If you are not familiar with the particular marina, it is worthwhile going past your mooring first to take a look at the mooring cleats or bollards. Check where the wind and tide is coming from and brief the crew accordingly.
Put your fenders out on the side of the that will be against the dock, making sure you have enough to protect the full length of your boat. They should be at the right height for the dock and should be spread out along the length of the boat. The rearmost fender should be about level with the rear stanchion and the foremost between the first guardrail and pulpit.
Mooring ropes should be attached to the bow and stern cleats of the and should be passed through the fairleads and underneath the guardrails so that the guardrails are not snagged when the lines are secured to the dock. Usually, the crew members will hold these lines with three or four coils in their hands and stand at the widest point of the ready to jump onto the dock when it's close enough.
Ideally, the should approach the pontoon heading into the wind or tide at an angle of about 30-40°. Turning the bow away from the dock as it gets close will make the stern come in, then the is stopped by putting the engine into reverse.
The two crew members holding the bow and stern lines now step onto the dock and secure the lines to the dock cleats.
If the is only to be moored up for a very short time (for example when re-fuelling) and the weather conditions are calm, the bow and stern lines may be enough. However, boats moored only on bow and stern lines will move back and forth along the dock.
Adding spring lines
Ohio River Flood Index at the City of Pittsburgh
Display current water levels of the Ohio River and Flood action stages around the Pittsburgh area.
Current Boating conditions around the city of Pittsburgh
Check Pittsburgh Area weather and boating conditions.
Allegheny County Boating Rule Amendments
Extended Rules of the PA Boater Laws for Allegheny County.
Allegheny County Boating Rule Amendments
Extended Rules of the PA Boater Laws for Allegheny County.
Pennsylvaina Boating Laws (Highlights)
An Abridged Version of Pennsylvania's Boating Laws.
Pennsylvaina Minimal Required Boating Equipment
A list of the minimal amount of equipment required when boating in
Pennsylvania.
Pennsylvaina Locks and Dams Procedures
Information related to traveling through Pennsylvania's Locks and Dams.
Pennsylvaina Hull Identification Numbers
Information related to the Hull Identification Numbers (HIN) on Pennsylvania Boats.
Pennsylvaina Personal Floatation Device Regulations
Requirements for Personal Floatation Devices on Pennsylvanian's Boats.
Pennsylvaina Boat Titling Information
Information regarding Boat Titling in Pennsylvania.
Newport Marina Boat Maintenace Tips
Information on how to maintain motor boats.
Newport Marina Boat Launch Ramp Rules
The General Boat Ramps Rules and Etiquette for Public Ramps.
Newport Marina Pittsburgh Steeler and Pittsburgh Pirates Stuffed Collector Dolls
Stuffed animal Collector dolls wearing Pittsburgh Steeler Apparel.
Newport Marina Pittsburgh Steeler and Pittsburgh Pirates Stuffed Rabbit Collector Dolls
Stuffed Rabbit Collector Dolls wearing Pittsburgh Steeler and Pittsburgh Pirates Apparel.
Newport Marina Pittsburgh Steeler Stuffed Bear Collector Dolls
Stuffed Bear Collector Dolls wearing Pittsburgh Steeler Apparel.
will prevent this movement and should be employed whenever mooring up for any length of time. The stern spring should run from the stern of the to a position on the dock close to the bow of the boat. Similarly, the bow spring is used to stop forward motion of the and thus should run from the bow to an aft position on the dock. Commonly the stern spring is attached to the same cleat on the dock as the bow line, and the bow spring is tied off to the stern line dock cleat.
Mooring Alongside Another Boat
Ideally you'll want to moor directly against the pontoon or dock. However, in peak season, there may not be enough space in the marina to do so. In this case you'll have to moor alongside another vessel.
It is best to moor against a of a similar size or larger than your own. Sailing and power boats don't moor alongside well because of their different shapes. Where possible, you should ask permission before mooring against another boat. Preferably choose a that intends to leave the marina at the same time or later than you.
Breast ropes should be used between the bows and sterns of each and spring lines should be secured from the bow of each to stern of the other. It is also a good idea to attach lines from the bow and stern of the outer directly to the dock. This ensures that the force of the wind or tide is shared between the boats.
Make sure that the masts of the two boats are offset. If they are in line, then waves may roll the boats making the masts collide with each other.
Leaving From An Inside Berth When Another Is Rafted Alongside
The easiest way for rafted boats to depart the marina is for the outside to leave first. However, this is not always possible.
In the event that the inner needs to leave first, ideally, it should leave the dock travelling down-wind or down-tide.
Both boats should start their engines and have all ropes removed except direct bow and stern shore lines.
The immediately outside of the one that is leaving should have a line running from its stern around the front of the leaving and back to the dock. As the inner reverses out, the outer moves forwards and takes up the slack on the bow line and new stern line. Article Source: Article Beam - a service of A1 Web Server Web Hosting TheYachtMarket.com has additional boating articles, a popular forum for sailing and power boating and lists boats for sale of all types from all over the world. They also have packages for both brokers and private sellers to sell boats.
|
